All Around Triple Single Bracelet
Summary:
Skill Level: Advanced
Supplies Required: 16 Red, 16 Orange, 16 Yellow, 16 Green, 16 Blue, 16 Purple, 3 Clips for patterns, 3 Clips temporary
Description: If you have made the Triple Single bracelet, this is the next challenge to this design. This bracelet is made using only 1 loom, and uses some additional Clips temporarily to hold half the pattern, while the other half is being worked on on the loom.
A picture of the All Around Triple Single Bracelet
A video tutorial to make the All Around Triple Single Bracelet
Step-by-Step Instructions for the All Around Triple Single Bracelet
1) All Around Triple Single
2) 16 Red, 16 Orange, 16 Yellow, 3 Temporary Clips, 16 Green, 16 Blue, 16 Purple, 3 Clips
3) Place the loom into a grid pattern by moving middle pegs to align with outside pegs
4) Position loom so arrows are pointing upwards
5) From bottom to top, across all 3 columns, repeat the following colors:
- red
- orange
- yellow
- green
- blue
- purple
6) From bottom to top, place elastics across all 3 columns:
- red
- orange
- yellow
- green
- blue
- purple
7) Rotate the loom so the arrows are pointing down
8) Place a clip onto each of the bottom elastics so it captures both strands of the same elastic
9) From bottom to top, loop the elastics from the bottom pegs to the next upper peg
10) Place 3 Clips onto all all elastics on the top row of pegs
11) Carefully, remove the pattern from the loom
12) Ensure that each Clip still has 3 loops on it
13) Place this pattern off to the side, and rotate loom so arrows are pointing up
14) Again, from bottom to top, across all 3 columns, repeat the following colors:
- red
- orange
- yellow
- green
- blue
- purple
15) From bottom to top, place elastics across all 3 columns:
- red
- orange
- yellow
- green
- blue
- purple
16) Carefully place the red elastics onto the top pegs of the loom
17) Keep the Clips on for now, and rotate loom so arrows are pointing down
18) From bottom to top, loop the elastics from the bottom pegs to the next upper peg
19) Starting from the bottom of the loom, remove about half of the pattern from the loom
20) Rotate the loom so the arrows are pointing up
21) Adjust the elastics on the Clips so the elastics are on one side of the clip
22) Using your loom tool to assist, place all 3 clips onto all elastics on the bottom pegs
23) You can now remove the entire pattern from the loom
24) Remove the temporary clips from the middle of the pattern
25) All Around Triple Single